Hydraulic Scrap Grab Bucket

It can work in all kinds of harsh environments, and the unique jaw flap curve is especially favorable for loading and unloading irregular materials such as scrap steel and pig iron. The hydraulic grapple has 2-6 jaw flaps, each of which is driven by a cylinder respectively to ensure that the material will not be spilled, the specific features are as follows:

1. Small heat generation, can save energy, can effectively reduce the hydraulic system due to heat and produce various failures;
2. High operating efficiency, effectively improve the gripping efficiency;
3. Motor start, the current is small, can effectively protect the electrical components, reduce the load bearing, to ensure that the whole set of equipment for normal operation;
4. Hydraulic system start-up impact pressure is small, will not cause pipe burst phenomenon;
5. The system has a high degree of automation, stable operation;
6. Low maintenance costs, simple structure is conducive to maintenance;
7. High stability and low noise in operation;
8. Tested by customers, the grab continuous working ability, the longest continuous 24 hours of work, and low failure rate.

Precautions for use:

1. In the use, if you find the rotation is not sensitive, or not rotating in place, then the hydraulic grab adjusting nut should stop checking and adjusting.
2. Check the tension spring, transmission mechanism, whether there is broken and other problems, if any problem, should be suspended in time to deal with.
3. The wire rope on the top of the grapple should be cleaned regularly, and the necessary lubrication should also be carried out. Grease or lubricating oil can be used, and should not miss the bend of the hydraulic grab.
4. The main force parts in the grab, such as rings, locks, buckles, etc., should be suspended at regular intervals, whether there is deformation, cracking, etc., should be replaced in a timely manner.
5. The main joint lubrication of the scrap steel grab should be stopped to ensure that it can work normally.